Function and Feature
■ Lead Fluid industrial micro syringe pump G6060-1S mainly suitable for high-precision micro liquid of continuous transmission, dilution and dispensing.
■ Rated stroke 60mm, standard mode 6000 steps，microstep mode up to 48000 steps.
■ Stepper motor, backlash compensation screw assembly drive, mechanical reversal with extremely high transmission stability and accuracy.
■ Can assembly a 50ul-25ml gas tight syringe, and the linear velocity range is wider.
■ The material of the valve body and the fluid path has excellent chemical properties, adapting to various neutral and corrosive solutions.
■ It can be used in various ways, it can be controlled by external signal, it can also be controlled by PC communication or it can run automatically offline.
Schematic diagram（Three-port valve）
|Running time||1.2 s~100 min（Rated stroke）|
|Flow accuracy||error≤1%（Rated stroke）|
|Flow repeatability||CV≤0.05%（Rated stroke，25℃ Deionized water，1ml and above syringe）|
|Power supply||DC 24V/2.0A|
|Control resolution||standard mode 6000 steps，microstep mode 48000 steps（rated stroke）|
|Syringe fitting||1/4-28UNF inner thread|
|Syringe material||Borosilicate glass syringe, stainless steel push rod, PTFE piston|
|Piston drive||Stepper motor，Backlash compensation screw assembly drive, orthogonal encoding to detect position|
|Reversing valve||standard：120°3 port|
|Valve position time||≤250 millisecond（Between two adjacent valves）|
|Valve material||PTFE, PCTFE|
|Valve fitting||1/4-28UNF inner thread|
|Signal input||2 gates TTL Level signal input (drive current＞16mA)|
|Signal output||3 gates TTL level signal outpump|
|Protocol||DT protocol, ODM protocol|
|Bit rate||9600bps/38400bps can set|
|Parameter setting||7 digit dial switch|
|Chain communication||Supports up to 15 pump communication, no converter is needed to realize the conversion of RS232 and RS485|
|Firmware upgrade||Upgrade via computer RS232 interface|
|Programming function||Ramp, cut-off speed, gap compensation, injection speed, cycle,Real-time termination of movement and delay, error detection, valve rotation selection, storage of 15 groups of operating modes|
|Working environment||temperature 15℃~40℃，relative humidity＜80%|
|Min Flow (ml/min)||0.0003125||0.000625||0.001563||0.003125||0.00625||0.03125||0.0625||0.15625|
|Max Flow (ml/min)||2.5||5.0||12.5||25||50||250.0||500.0||1250.0|
Above flow parameters are obtained by using silicone tube to transfer pure water under normal temperature and pressure, in actually using it is effected by specific factors such as pressure, medium etc. Above for reference only.
Connector and Pipeline
Thread inverted taper joint